Search
R&S
®
RTM20xx
137User Manual 1317.4726.02 ─ 01
"Protocol"
The protocol search finds various events in decoded data of CAN and
LIN signals, for example, a specified frame type, identifier, data, and
errors.The protocol search requires option R&S RTM-K3.
For information on protocol search, see
● chapter 11.5.5, "Search on Decoded CAN Data", on page 194
● chapter 11.6.6, "Search on Decoded LIN Data", on page 205
Remote command:
SEARch:CONDition on page 359
Setup
Opens a menu to define the specific search parameters.
Source
Selects the waveform to be analyzed with edge, width, peak, rise/fall time, or runt search.
All active channel, math, and reference waveforms are available for selection.
Remote command:
SEARch:SOURce on page 361
Source Setup
Opens a menu to define the source parameters for Data2Clock and Pattern search:
waveform, level, and hysteresis.
Gate
Opens a menu to restrict the time base range of the source waveform for search.
See chapter 10.3.9, "Gate Menu", on page 146
Events
Opens a menu with functions for result display and marker usage.
See: chapter 10.3.10, "Events Menu", on page 147
Remote command:
SEARch:RESDiagram:SHOW on page 372
10.3.2 Edge Setup
Access: SEARCH MENU > "Search type = Edge" > "Setup"
Edge
Sets the slope to be found:
"Rising"
Rising edge, a positive voltage change
"Falling"
Falling edge, a negative voltage change
Reference for Search Menu
To Next Page
Loading...
