Rohde & Schwarz RTM2032 - Page 295

Remote Control
R&S
®
RTM20xx
280User Manual 1317.4726.02 ─ 01
Example:
See chapter 15.3.1.2, "Reading Waveform Data in Unsigned Inte-
ger Format", on page 458
Usage: Query only
CHANnel<m>:DATA:XINCrement?
CHANnel<m>:DATA:ENVelope:XINCrement?
CALCulate:MATH<m>:DATA:XINCrement?
REFCurve<m>:DATA:XINCrement?
Return the time difference between two adjacent samples of the indicated waveform.
The commands are relevant for data conversion if binary data format is defined
(FORM UINT, 8|16|32).
Return values:
<Xincrement> Time in s
Example:
See chapter 15.3.1.2, "Reading Waveform Data in Unsigned Inte-
ger Format", on page 458
Usage: Query only
CHANnel<m>:DATA:YORigin?
CHANnel<m>:DATA:ENVelope:YORigin?
CALCulate:MATH<m>:DATA:YORigin?
REFCurve<m>:DATA:YORigin?
Return the voltage value for binary value 0 of the indicated waveform.
The commands are relevant for data conversion if binary data format is defined
(FORM UINT, 8|16|32).
Return values:
<Yorigin> Voltage in V
Example:
See chapter 15.3.1.2, "Reading Waveform Data in Unsigned Inte-
ger Format", on page 458
Usage: Query only
CHANnel<m>:DATA:YINCrement?
CHANnel<m>:DATA:ENVelope:YINCrement?
CALCulate:MATH<m>:DATA:YINCrement?
REFCurve<m>:DATA:YINCrement?
Return the voltage value per bit of the indicated waveform.
The commands are relevant for data conversion if binary data format is defined
(FORM UINT, 8|16|32).
Return values:
<Yincrement> Voltage in V
Command Reference