Rohde & Schwarz RTM2032 - Page 336

Remote Control
R&S
®
RTM20xx
321User Manual 1317.4726.02 ─ 01
TIMebase:ZOOM:POSition <Position>
Defines the position of the zoom reference point (the reference point of the zoom window)
in relation to the reference point of original time base.
Parameters:
<Position> Range: Depends on the zoom time base, nearly 0 to 100 %
for large zoom
*RST: 50
Default unit: %
15.2.6.3 Markers (Timestamps)
TSTamp:SET.................................................................................................................321
TSTamp:NEXT..............................................................................................................321
TSTamp:PREVious........................................................................................................321
TSTamp:CLEar..............................................................................................................321
TSTamp:ACLear............................................................................................................321
TSTamp:SET
Sets a new marker (timestamp) at the reference point of the display, unless an existing
marker is already set there. The reference point is set with TIMebase:REFerence.
Usage:
Event
TSTamp:NEXT
Usage:
Event
Moves the next marker (timestamp, to the right) to the reference point of the display or
zoom area.
TSTamp:PREVious
Moves the previous marker (timestamp, to the left) to the reference point of the display
or zoom area.
Usage:
Event
TSTamp:CLEar
Deletes the marker (timestamp) at the reference point. The reference point is set with 
TIMebase:REFerence.
Usage:
Event
TSTamp:ACLear
Deletes all markers (timestamps).
Command Reference