Rohde & Schwarz RTM2032 - Page 299

Remote Control
R&S
®
RTM20xx
284User Manual 1317.4726.02 ─ 01
Usage: Query only
TIMebase:POSition <Offset>
Defines the trigger position (trigger offset) - the time interval between trigger point and
reference point to analize the signal some time before or after the trigger event.
See also: TIMebase:REFerence on page 284
Parameters:
<Offset> Range: Depends on time base setting
*RST: 0
Default unit: s
TIMebase:
REFerence <ReferencePoint>
Sets the reference point of the time scale (Time Reference) in % of the display. The
reference point defines which part of the waveform is shown. If the trigger position is zero,
the trigger point matches the reference point.
See also: TIMebase:POSition on page 284
Parameters:
<ReferencePoint> Range: 10 to 90
Increment: 10
*RST: 50
Default unit: %
15.2.4.3 Acquisition
AUToscale....................................................................................................................284
ACQuire:MODE.............................................................................................................285
ACQuire:INTerpolate......................................................................................................285
ACQuire:AVERage:COUNt.............................................................................................285
ACQuire:WRATe............................................................................................................286
CHANnel<m>:TYPE.......................................................................................................286
CHANnel<m>:ARIThmetics.............................................................................................287
TIMebase:ROLL:ENABle................................................................................................287
ACQuire:FILTer:FREQuency...........................................................................................287
ACQuire:POINts:ARATe?...............................................................................................288
ACQuire:SRATe?...........................................................................................................288
AUToscale
Performs an autoset process: analyzes the enabled channel signals, and obtains appro-
priate horizontal, vertical, and trigger settings to display stable waveforms.
Usage:
Event
Asynchronous command
Command Reference