Rohde & Schwarz RTM2032 - Page 229

Mixed Signal Option (MSO, R&S RTM-B1)
R&S
®
RTM20xx
214User Manual 1317.4726.02 ─ 01
12.3.3.2 Parallel Bus - Decode Results
You can enable the decoding in the "Protocol" main menu. "Decode" shows the decoded
values below the waveforms in the format selected with "Display". Additionally, you can
display the binary signal with "Bits".
See also: chapter 11.1.2, "Protocol - Common Settings", on page 149
Additionally, you can display and save a "Frame Table" containing decoded data: frame
number, start time of the frame, identifier, data length, data, checksum, and state of the
frame.
See also: chapter 11.1.5, "Frame Table: Decode Results", on page 154
Remote commands:
● BUS<b>:PARallel:FCOunt? on page 439
● BUS<b>:PARallel:FRAMe<n>:DATA? on page 439
● BUS<b>:PARallel:FRAMe<n>:STATe? on page 440
● BUS<b>:PARallel:FRAMe<n>:STARt? on page 440
● BUS<b>:PARallel:FRAMe<n>:STOP? on page 440
Parallel Buses