Rohde & Schwarz RTM2032 - Page 350

Remote Control
R&S
®
RTM20xx
335User Manual 1317.4726.02 ─ 01
MEASurement<m>:ALL[:STATe]
Starts or stops the quick measurement and sets the status bit.
Parameters:
<State> ON | OFF
*RST: OFF
Firmware/Software: FW 03.800
MEASurement<m>:AON
Starts the quick measurement.
Suffix:
<m>
.
1..4
The numeric suffix is irrelevant.
Usage: Event
MEASurement<m>:AOFF
Stops the quick measurement.
Suffix:
<m>
.
1..4
The numeric suffix is irrelevant.
Usage: Event
MEASurement<m>:ARESult?
Returns the results of the quick measurement.
Suffix:
<m>
.
1..4
Selects the measurement.
Return values:
<QuickMeasData> List of values
Quick measurement results are listed in the following order: PEAK,
UPE, LPE, CYCR, CYCM, PER, FREQ, RTIM , FTIM
Usage: Query only
15.2.8.3 Automatic Measurements
MEASurement<m>[:ENABle]...........................................................................................336
MEASurement<m>:MAIN................................................................................................336
MEASurement<m>:SOURce...........................................................................................338
Command Reference