Rohde & Schwarz RTM2032 - Page 351

Remote Control
R&S
®
RTM20xx
336User Manual 1317.4726.02 ─ 01
MEASurement<m>:DELay:SLOPe...................................................................................339
MEASurement<m>:RESult[:ACTual]?..............................................................................340
MEASurement<m>:CATegory?.......................................................................................340
MEASurement<m>[:ENABle] <State>
Activates or deactivates the selected measurement (1-4). Only the results of active
measurements are displayed in the result table.
Suffix:
<m>
.
1..4
Selects the measurement.
Parameters:
<State> ON | OFF
*RST: OFF
MEASurement<m>:
MAIN <MeasType>
Defines the measurement type to be performed on the selected source. To query the
results, use MEASurement<m>:RESult[:ACTual]?.
Suffix:
<m>
.
1..4
Selects the measurement.
Command Reference