Remote Control
R&S
®
RTM20xx
340User Manual 1317.4726.02 ─ 01
<ReferenceSlope> POSitive | NEGative
Slope of source 2 (second waveform)
*RST: POS
Firmware/Software: 03.400
MEASurement<m>:RESult[:ACTual]? [<MeasType>]
Returns the result of the specified measurement type.
Suffix:
<m>
.
1..4
Selects the measurement place.
Query parameters:
<MeasType> FREQuency | PERiod | PEAK | UPEakvalue | LPEakvalue |
PPCount | NPCount | RECount | FECount | HIGH | LOW |
AMPLitude | MEAN | RMS | RTIMe | FTIMe | PDCYcle | NDCYcle |
PPWidth | NPWidth | CYCMean | CYCRms | STDDev |
CYCStddev | TFRequency | TPERiode | DELay | PHASe |
BWIDth | POVershoot | NOVershoot | TBFRequency | TBPeriod
Specifies the measurement type. See MEASurement<m>:MAIN
on page 336.
Return values:
<Value> Measurement result. If no measurement was executed, no value
(NAN) is returned.
Usage: Query only
MEASurement<m>:CATegory?
Returns the measurement category. Currently, the instrument supports only yt-meas-
urements.
Suffix:
<m>
.
1..4
Selects the measurement.
Return values:
<Category> AMPTime
AMPtime: yt-measurements
*RST: AMPT
Usage: Query only
Command Reference
To Next Page
Loading...
