Remote Control
R&S
®
RTM20xx
392User Manual 1317.4726.02 ─ 01
TRIGger:A:I2C:POFFset <PatternByteOffset>
Sets the number of bytes before the first byte of interest, relating to the end of the address
bytes.
Parameters:
<PatternByteOffset> Number of ignored bytes
Range: 0 to 4095
Increment: 1
*RST: 0
I²C - Decode Results
BUS<b>:I2C:FCOunt?....................................................................................................392
BUS<b>:I2C:FRAMe<n>:DATA?.....................................................................................392
BUS<b>:I2C:FRAMe<n>:STATus?..................................................................................393
BUS<b>:I2C:FRAMe<n>:STARt?....................................................................................393
BUS<b>:I2C:FRAMe<n>:STOP?.....................................................................................394
BUS<b>:I2C:FRAMe<n>:AACCess?................................................................................394
BUS<b>:I2C:FRAMe<n>:ACCess?..................................................................................394
BUS<b>:I2C:FRAMe<n>:ACOMplete?.............................................................................395
BUS<b>:I2C:FRAMe<n>:ADBStart?................................................................................395
BUS<b>:I2C:FRAMe<n>:ADDRess?................................................................................395
BUS<b>:I2C:FRAMe<n>:ADEVice?.................................................................................396
BUS<b>:I2C:FRAMe<n>:AMODe?..................................................................................396
BUS<b>:I2C:FRAMe<n>:ASTart?....................................................................................396
BUS<b>:I2C:FRAMe<n>:BCOunt?..................................................................................397
BUS<b>:I2C:FRAMe<n>:BYTE<o>:ACCess?...................................................................397
BUS<b>:I2C:FRAMe<n>:BYTE<o>:ACKStart?.................................................................397
BUS<b>:I2C:FRAMe<n>:BYTE<o>:COMPlete?................................................................398
BUS<b>:I2C:FRAMe<n>:BYTE<o>:STARt?.....................................................................398
BUS<b>:I2C:FRAMe<n>:BYTE<o>:VALue?.....................................................................398
BUS<b>:I2C:FCOunt?
Returns the number of received frames.
Suffix:
<b>
.
1..4
Selects the bus.
Return values:
<FrameCount> Total number of decoded frames.
Usage: Query only
BUS<b>:I2C:FRAMe<n>:DATA?
Returns the data words of the specified frame.
Command Reference
To Next Page
Loading...
