Rohde & Schwarz RTM2032 - Page 404

Remote Control
R&S
®
RTM20xx
389User Manual 1317.4726.02 ─ 01
BUS<b>:I2C:CLOCk:SOURce <Source>
Sets the input channel to which the clock line is connected.
Suffix:
<b>
.
1..4
Selects the bus.
Parameters:
<Source> CH1 | CH2 | CH3 | CH4 | D0..D15
CH3 and CH4 are only available with 4-channel R&S RTM oscil-
loscopes.
*RST: CH1
BUS<b>:
I2C:DATA:SOURce <Source>
Sets the input channel to which the data line is connected.
Suffix:
<b>
.
1..4
Selects the bus.
Parameters:
<Source> CH1 | CH2 | CH3 | CH4 | D0..D15
CH3 and CH4 are only available with 4-channel R&S RTM oscil-
loscopes.
*RST: CH1
CHANnel<m>:THReshold:FINDlevel
Executes the analysis of all analog channels that are configured for the selected bus and
sets the threshold for digitization of analog signals for each channel.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Usage: Event
I²C - Trigger
TRIGger:A:I2C:MODE....................................................................................................390
TRIGger:A:I2C:ACCess..................................................................................................390
TRIGger:A:I2C:AMODe..................................................................................................390
TRIGger:A:I2C:ADDRess................................................................................................391
TRIGger:A:I2C:PATTern.................................................................................................391
TRIGger:A:I2C:PLENgth.................................................................................................391
TRIGger:A:I2C:POFFset.................................................................................................392
Command Reference