Rohde & Schwarz RTM2032 - Page 392

Remote Control
R&S
®
RTM20xx
377User Manual 1317.4726.02 ─ 01
Example:
BUS:LIST:SAVE "/USB_FRONT/MYTABLE.CSV"
Saves the frame table data to the MYTABLE.CSV file on a USB
flash device connected to the front panel.
Usage: Setting only
15.2.13.2 SPI
The Serial Peripheral Interface SPI is used for communication with slow peripheral devi-
ces, in particular, for transmission of data streams. A 4-channel instrument is required
for full support of the SPI protocol.
The SPI/SSPI protocol require two bus lines (bus 1 and 2 or bus 3 and 4), so the number
of buses (suffix <b>) is reduced. Bus 2 and/or bus 4 is not available.
● SPI - Configuration................................................................................................377
● SPI - Trigger..........................................................................................................380
● SPI - Decode Results............................................................................................381
SPI - Configuration
BUS<b>:SPI:CS:SOURce...............................................................................................377
BUS<b>:SPI:CS:POLarity...............................................................................................377
BUS<b>:SPI:CLOCk:SOURce.........................................................................................378
BUS<b>:SPI:CLOCk:POLarity.........................................................................................378
BUS<b>:SPI:DATA:SOURce...........................................................................................378
BUS<b>:SPI:DATA:POLarity...........................................................................................379
BUS<b>:SPI:BORDer.....................................................................................................379
BUS<b>:SPI:SSIZe........................................................................................................379
CHANnel<m>:THReshold:FINDlevel................................................................................379
BUS<b>:SPI:CS:SOURce <Source>
Selects the input channel of the chip select line.
Suffix:
<b>
.
1..4
Selects the bus.
Note: SPI/SSPI and UART protocols occupy two bus lines.
Parameters:
<Source> CH1 | CH2 | CH3 | CH4 | D0..D15
*RST: CH1
BUS<b>:SPI:CS:POLarity <Polarity>
Selects whether the chip select signal is high active (high = 1) or low active (low = 1).
Suffix:
<b>
.
1..4
Selects the bus.
Note: SPI/SSPI and UART protocols occupy two bus lines.
Command Reference