Rohde & Schwarz RTM2032 - Page 379

Remote Control
R&S
®
RTM20xx
364User Manual 1317.4726.02 ─ 01
Firmware/Software: FW 03.400
SEARch:TRIGger:WIDTh:WIDTh <Width>
Sets the reference pulse width, the nominal value for comparisons.
Parameters:
<Width> Default unit: s
Example:
chapter 15.3.2.1, "Searching for a Pulse of Specified Width",
on page 460
Firmware/Software: FW 03.400
SEARch:TRIGger:WIDTh:DELTa <DeltaWidth>
Sets a range Δt to the reference pulse width set with SEARch:TRIGger:WIDTh:
WIDTh if SEARch:TRIGger:WIDTh:RANGe is set to WITHin or OUTSide
Parameters:
<DeltaWidth> Range: Lower limit depends on the resolution, practically no
upper limit
Example:
chapter 15.3.2.1, "Searching for a Pulse of Specified Width",
on page 460
Firmware/Software: FW 03.400
15.2.12.4 Peak Search Configuration
SEARch:MEASure:PEAK:POLarity..................................................................................364
SEARch:MEASure:LEVel:PEAK:MAGNitude.....................................................................364
SEARch:MEASure:PEAK:POLarity <Polarity>
Indicates the polarity of a the pulse to be searched for a peak.
Parameters:
<Polarity> POSitive | NEGative | EITHer
*RST: POS
Firmware/Software: FW 03.400
SEARch:MEASure:LEVel:PEAK:MAGNitude <Magnitude>
Sets the amplitude limit.
Parameters:
<Magnitude> Default unit: V
Firmware/Software: FW 03.400
Command Reference