Rohde & Schwarz RTM2032 - Page 447

Remote Control
R&S
®
RTM20xx
432User Manual 1317.4726.02 ─ 01
SEARch:PROTocol:LIN:DLENgth....................................................................................434
SEARch:PROTocol:LIN:DCONdition................................................................................434
SEARch:PROTocol:LIN:DATA.........................................................................................434
SEARch:PROTocol:LIN:CONDition <SearchCondition>
Sets the event or combination of events to be searched for. Depending on the selected
event, further settings are required.
Parameters:
<SearchCondition> FRAMe | ERRor | IDENtifier | IDData | IDERror
FRAMe
Search for a frame type.
Set the frame type with SEARch:PROTocol:LIN:FRAMe.
ERRor
Search for errors of one or more error types.
Set the error types with SEARch:PROTocol:LIN:CHKSerror, 
SEARch:PROTocol:LIN:IPERror, and SEARch:PROTocol:
LIN:SYERror.
IDENtifier
Search for identifier.
Specifiy the identifier with SEARch:PROTocol:LIN:
ICONdition and SEARch:PROTocol:LIN:IDENtifier.
IDData
Search for identifier and data.
Set the identifier (see IDENtifier) and the data with SEARch:
PROTocol:LIN:DLENgth, SEARch:PROTocol:LIN:
DCONdition, and SEARch:PROTocol:LIN:DATA.
IDERror
Search for errors that occur with a specified identifier. Set the
identifier (see IDENtifier) and the errors to be found (see ERRor).
*RST:
FRAM
SEARch:PROTocol:LIN:FRAMe <Frame>
Selects the frame type to be searched for.
The command is relevant if SEARch:PROTocol:LIN:CONDition is set to FRAMe.
Parameters:
<Frame> SOF | WAKeup
SOF: start of frame
WAKeup: Wakeup frame
*RST: SOF
Command Reference