Rohde & Schwarz RTM2032 - Page 448

Remote Control
R&S
®
RTM20xx
433User Manual 1317.4726.02 ─ 01
SEARch:PROTocol:LIN:IPERror <IdParityError>
Searches for parity errors.
The command is relevant if SEARch:PROTocol:LIN:CONDition is set to ERRor or
IDERror.
Parameters:
<IdParityError> ON | OFF
*RST: OFF
SEARch:PROTocol:LIN:CHKSerror <ChecksumError>
Searches for checksum errors.
The command is relevant if SEARch:PROTocol:LIN:CONDition is set to ERRor or
IDERror.
Parameters:
<ChecksumError> ON | OFF
*RST: OFF
SEARch:PROTocol:LIN:SYERror <SyncError>
Searches for synchronization errors.
The command is relevant if SEARch:PROTocol:LIN:CONDition is set to ERRor or
IDERror.
Parameters:
<SyncError> ON | OFF
*RST: OFF
SEARch:PROTocol:LIN:ICONdition <IdCondition>
Sets the comparison condition for the identifier: If the pattern contains at least one X (don't
care), you can trigger on values equal or not equal to the specified value. If the pattern
contains only 0 and 1, you can also trigger on a range greater than or lower than the
specified value.
The command is relevant if SEARch:PROTocol:LIN:CONDition is set to
IDENtifier, IDData or IDERror.
Parameters:
<IdCondition> EQUal | NEQual | GTHan | LTHan
*RST: EQU
SEARch:PROTocol:LIN:IDENtifier <Identifier>
Defines the identifier pattern.
Command Reference