Rohde & Schwarz SMC100A - Page 275

Remote Control Commands
R&S
®
SMC100A
260Operating Manual 1411.4060.32 ─ 09
Query parameters:
<Path> string
String parameter to specify the directory. If the directory is omit-
ted, the command queries the content of the current directory,
queried with :MMEMory:CDIRectory command.
Return values:
<FileCount> integer
Number of files.
Example: See "Working with Files and Directories" on page 258.
Usage: Query only
:MMEMory:CDIRectory <Directory>
Changes the default directory for mass memory storage. The directory is used for all
subsequent MMEM commands if no path is specified with them.
Parameters:
<Directory> <directory_name>
String containing the path to another directory. The path can be
relative or absolute.
To change to a higher directory, use two dots '..' .
Example: See "Working with Files and Directories" on page 258.
Usage: SCPI confirmed
Manual operation: See "Directory, File List and File Name" on page 112
:MMEMory:COPY <SourceFile>[,<DestinationFile>]
Copies an existing file to a new file. Instead of just a file, this command can also be
used to copy a complete directory together with all its files.
Setting parameters:
<SourceFile> string
String containing the path and file name of the source file
<DestinationFile> string
String containing the path and name of the target file. The path
can be relative or absolute.
If <DestinationFile> is not specified, the <SourceFile> is
copied to the current directory, queried with the :MMEMory:
CDIRectory command.
Note: Existing files with the same name in the destination direc-
tory are overwritten without an error message.
Example: See "Working with Files and Directories" on page 258.
Usage: Setting only
SCPI confirmed
MMEMory Subsystem