Remote Control Commands
R&S
®
SMC100A
327Operating Manual 1411.4060.32 ─ 09
Parameters:
<Mode> SINGle | DOUBle
SINGle
Enables single pulse generation.
DOUBle
Enables double pulse generation. The two pulses are generated
in one pulse period.
*RST: SINGle
Example:
PULM:MODE DOUB
enables double pulse generation.
Manual operation: See " Pulse Mode - Pulse Generator " on page 187
[:SOURce<hw>]:PULM:PERiod <Period>
Sets the period of the generated pulse. The period determines the repetition frequency
of the internal signal.
Parameters:
<Period> float
Range: 2 us to 85 s
Increment: 100 ns
*RST: 1 ms
Example:
PULM:PER 220 us
the pulse period is 220 us.
Manual operation: See " Pulse Period - Pulse Generator " on page 187
[:SOURce<hw>]:PULM:POLarity <Polarity>
Sets the polarity between modulating and modulated signal. This command is effective
only for an external modulation signal.
Parameters:
<Polarity> NORMal | INVerted
NORMal
The RF signal is suppressed during the pulse pause.
INVerted
The RF signal is suppressed during the pulse.
*RST: NORMal
Example:
PULM:SOUR EXT
selects the external modulation source.
Example:
PULM:POL INV
selects inverted polarity.
Manual operation: See " Polarity " on page 179
SOURce Subsystem
To Next Page
Loading...
