Rohde & Schwarz SME02 - Page 441

SME List of Commands
1038.6002.02 8C.11 E-12
Command
Parameter
SCPI
info
Page
[:SOURce]:POCSag:MESSage:ALPHanumeric[:SELect] 3.84
[:SOURce]:POCSag:MESSage:CATegory NUMeric | TONE | ALPHanumeric not-SCPI 3.83
[:SOURce]:POCSag:MESSage:NUMeric ’String’ not-SCPI 3.84
[:SOURce]:POCSag:MESSage:SWORd POCSag | INForuf not-SCPI 3.84
[:SOURce]:POCSag:MESSage:TONE A | B | C | D not-SCPI 3.84
[:SOURce]:POCSag:MODulation FSK | FFSK not-SCPI 3.82
[:SOURce]:POCSag:POLarity NORMal | INVerted not-SCPI 3.85
[:SOURce]:POCSag:STATe ON | OFF not-SCPI 3.82
[:SOURce]:POCSag:TACTion MESSage | STARt | ONCE not-SCPI 3.85
[:SOURce]:POCSag:TSLice 2 to 120 sec not-SCPI 3.85
[:SOURce]:POWer:ALC:BANDwidth | BWIDth:AUTO ON | OFF | ONCE not-SCPI 3.86
[:SOURce]:POWer:ALC:BANDwidth|BWIDth 100 kHz | 500 kHz not-SCPI 3.86
[:SOURce]:POWer:ALC[:STATe] ON | OFF 3.87
[:SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude] -144 to+16 dBm 3.87
[:SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude]:OFFSet -100 to+100 3.87
[:SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude]:RCL INCLude | EXCLude 3.87
[:SOURce]:POWer:LIMit[:AMPLitude] -144 to +16 dBm 3.88
[:SOURce]:POWer:MANual -144 to + 16 dBm 3.88
[:SOURce]:POWer:MODE FIXed | SWEep | LIST 3.88
[:SOURce]:POWer:STARt -144 to +16 dBm 3.88
[:SOURce]:POWer:STEP[:INCRement] 0.1 to 10 dB 3.88
[:SOURce]:POWer:STOP -144 to +16 dBm 3.88
[:SOURce]:PULM:EXTernal:IMPedance 50 Ohm | 10 kOhm not-SCPI 3.89
[:SOURce]:PULM:INTernal:FREQuency 0.01176 Hz to10 MHz not-SCPI 3.89
[:SOURce]:PULM:POLarity NORMal | INVerted not-SCPI 3.89
[:SOURce]:PULM:SOURce EXTernal | INTernal not-SCPI 3.89
[:SOURce]:PULM:STATe ON | OFF not-SCPI 3.89
[:SOURce]:PULSe:DELay 40 ns to 1 s not-SCPI 3.90