Rohde & Schwarz SME02 - Page 443

SME List of Commands
1038.6002.02 8C.13 E-12
Command
Parameter
SCPI
info
Page
[:SOURce]:REFLex25:STATe:AUTO ON | OFF not-SCPI 3.92
[:SOURce]:REFLex25:TACTion MESSage | STARt | ONCE not-SCPI 3.96
[:SOURce]:ROSCillator:EXTernal:FREQuency 1 to 16 MHz 3.97
[:SOURce]:ROSCillator[:INTernal]:ADJust[:STATe] ON | OFF not-SCPI 3.97
[:SOURce]:ROSCillator[:INTernal]:ADJust:VALue 0 to 4095 not-SCPI 3.97
[:SOURce]:ROSCillator:SOURce INTernal | EXTernal not-SCPI 3.97
[:SOURce]:STEReo:ARI:BK[:CODE] A | B | C | D | E | F not-SCPI 3.100
[:SOURce]:STEReo:ARI[:DEViation] 0 Hz to10 kHz not-SCPI 3.100
[:SOURce]:STEReo:ARI:TYPE BK | DK | OFF not-SCPI 3.100
[:SOURce]:STEReo:AUDio[:FREQuency] 0.1 Hz to 15 kHz not-SCPI 3.99
[:SOURce]:STEReo:AUDio:MODE RIGHt | LEFT | RELeft | REMLeft not-SCPI 3.99
[:SOURce]:STEReo:AUDio:PREemphasis OFF | 50 us | 75 u not-SCPI 3.99
[:SOURce]:STEReo[:DEViation] 0 Hz to 100 kHz not-SCPI 3.98
[:SOURce]:STEReo:PILot[:DEViation] 0 Hz to 10 kHz not-SCPI 3.99
[:SOURce]:STEReo:PILot:PHASe 0 to 360 deg not-SCPI 3.99
[:SOURce]:STEReo:PILot:STATe ON | OFF not-SCPI 3.99
[:SOURce]:STEReo:SIGNal AUDio | ARI not-SCPI 3.98
[:SOURce]:STEReo:STATe ON | OFF not-SCPI 3.98
[:SOURce]:SWEep:BTIMe NORMal | LONG not-SCPI 3.101
[:SOURce]:SWEep[:FREQuency]:DWELl 10 ms to 5 s not-SCPI 3.101
[:SOURce]:SWEep[:FREQuency]:MODE AUTO | MANual | STEP not-SCPI 3.102
[:SOURce]:SWEep[:FREQuency]:POINts Number not-SCPI 3.102
[:SOURce]:SWEep[:FREQuency]:SPACing LINear | LOGarithmic not-SCPI 3.102
[:SOURce]:SWEep[:FREQuency]:STEP:LOGarithmic 0.01 to 50 PCT not-SCPI 3.102
[:SOURce]:SWEep[:FREQuency]:STEP[:LINear 0 to 1 GHz not-SCPI 3.102
[:SOURce]:SWEep:POWer:DWELl 1 ms to 5 s not-SCPI 3.103
[:SOURce]:SWEep:POWer:MODE AUTO | MANual | STEP not-SCPI 3.103
[:SOURce]:SWEep:POWer:STEP:LOGarithmic 0 to 10 dB not-SCPI 3.103