Table of Contents
Page 4 of 104 CIRUS
®
UPT-6400 VERSION 1 | EN-US
5.5.2 Connection diagram 23
5.5.3 Supply voltage 26
6 Startup 27
6.1 Note on startup 27
6.2 Initial startup 27
6.3 Temperature controller configuration 28
6.3.1 Current transformer configuration 29
6.3.2 Setting temperature coefficient 29
6.3.3 Setting temperature range 29
7 Display and operating elements 30
7.1 Switching on device 30
7.2 Screen view 31
7.2.1 Standard screen 31
7.2.2 Adjusting screen brightness 31
7.2.3 Error message 31
8 Functions and settings 33
8.1 Settings 33
8.1.1 Settings menu / configuration menu 33
8.1.2 Menu navigation without alarm 47
8.1.3 Menu navigation in the event of an alarm 48
8.1.4 Default 49
8.2 Basic functions 52
8.2.1 Setting language 52
8.2.2 Temperature setting (specified setpoint) 53
8.2.3 Automatic zero calibration AUTOCAL (AC) 54
8.2.4 Configuring alarm relay 55
8.2.5 START signal 55
8.3 Inputs and outputs 57
8.3.1 RESET signal 57
8.3.2 Restart delay after reset 58
8.3.3 Temperature display / actual value output 58
8.3.4 Outputs relay K1, relay K2 and outputA1 60
8.3.5 USB interface 63
8.3.6 AUX interface 63
8.4 Diagnosis 64
8.4.1 Temperature diagnosis 64
8.4.2 Heatup timeout 64
8.4.3 Closing time monitoring 65
8.4.4 Maximum start temperature 65
8.4.5 Temperature tolerance 66
8.4.6 Cycle counter 66
8.5 Adjusting operation 66
8.5.1 Configuring the Manual button 66
8.5.2 Setting temperature unit 67
To Next Page
Loading...
