Rotax 125 Micro MAX - Clutch End Case Half Bearing Removal

DK00027.fm
REPAIR MANUAL
BRP-Powertrain
Effectivity: 125 MAX/125 Junior MAX/125 Mini
MAX/125 Micro MAX
Edition 2 / Rev. 0
Chapter 5
Page 12
December 01/2010
Safety
instructions
See Figure 6.
Instructions Clutch end case half
Graphic Clutch end case half
Figure 6 K00013, K00039

WARNING

WARNING
Danger of serious burns and scalding!
Wear safety gloves!
Step Procedure
1 Remove case half (1) from the convection oven and drop onto a flat wood
board with the case split pane. This releases the ball bearing (2) of the crank-
shaft and the balance shaft (3) from the case.
2 Invert the case half and drive out the needle bearing (5) with the installation
tool (4).
Part Function
1 Case half
2 Ball bearing (crankshaft)
3 Ball bearing (balance shaft)
4 Installation tool part no. 676030
5 Needle bearing
5
4
2
3
1