2.3.2 Fuse protection
The ROWE scanner must be protected by fuses (10 A).
2.3.3 Assembly and commissioning
The device shall only be connected to a grounded socket with VDE homologation and
located close to the machine. Check in advance whether the mains voltage complies with
the nominal voltage indicated on the type plate. The type plate is located on the left side
plate of the scanner (open scanner top). Please also consider the following aspects:
If the device is connected to an extension cord/a multiple socket, make sure that
the current draw of the devices connected to the extension cable/multiple socket
does not exceed the cable capacity. Make sure that not more than 10 A are
applied to the wall socket.
The plug connection shall be easily accessible without presenting any hazards.
The mains plug connection shall not obstruct access to the machine.
Make sure that no objects are placed onto the power cord. Make sure that
nobody steps onto the cord by mistake.
The components of the devices must not be installed nor removed using force.
2.3.4 Intended use
Never bypass any mechanical or electric disconnectors.
Do not remove any screwed parts.
It is not allowed to repair the scanner independently. Behind the covers which
can only be removed by means of a tool, there are components which are live or
bear hazards otherwise. Only authorized skilled service staff shall be charged
with maintenance in these areas of the scanner.
The housing is fitted with louvers at the bottom ensuring reliable operation. Do
not cover or close these louvers nor place any objects in front of them. In order
to prevent the above, the product must not be operated on soft furniture such as
beds, carpets, or other soft surfaces. Do not place the product close to or above
a heat source (radiator, etc.). It is allowed to place the product in closed furniture
or rooms only if sufficient ventilation is ensured.
Do not push any objects through the louvers of the scanner. Live components
may be touched, components may be short-circuited, and a fire or an electrical
shock may occur. Prevent liquids from getting onto the scanner.
Prior to any intervention in the electric or mechanical part of the device,
disconnect the power supply.
Only use cleaning agents which are approved by the manufacturer for the
respective purpose.
The printing, scanning, and folding systems shall only be modified by authorized
ROWE service staff.
Please observe the service intervals.
Use only original ROWE wearing and spare parts or wearing parts approved by
ROWE. Use of wearing parts which are not approved by ROWE may damage the
devices. ROWE does not accept any liability if wearing parts are used which are
not approved by ROWE.
Observe the safety notes on the wearing parts.
Dispose of packaging etc. according to the applicable legal regulations.
To Next Page
