Rowe Scan 850i - Finalizing Installation and Calibration

4.7 Shutting Down Computer – Connecting Scanner –
Switching ON Computer and Scanner
After actuating „Finish“ you are
prompted to shut the computer down
(Fehler! Verweisquelle konnte nicht
gefunden werden.). Please confirm by
actuating "Yes". Now wait until the
computer has been shut down and
switched OFF.
Figure 4.11: Prompt to shut computer
down
After having switched the computer
OFF, proceed as follows:
1. Connect the computer to the
scanner using the USB cable.
Use the supplied USB cable
(see Fehler!
Verweisquelle konnte
nicht gefunden werden.).
2. Connect the scanner to the
power supply using the
supplied power unit.
3. Switch the computer ON
again.
Figure 4.12: USB plug (connection
scanner)