Rowe Scan 850i - PC Requirements

Before installing the device, check the consignment for completeness. Check the scope of
supply by means of the list in Chapter 3.2 on Page 9.
Visible damages are to be notified in writing by a corresponding comment on the
consignment note. Otherwise, payment of damages by the carrier is excluded.
In order to avoid damages to the device, please do not place any tools,
components, or the like on the scanner!
3.5 PC Requirements
Use of the scanner requires connection of a PC (not included in the scope of supply). This
PC shall comply with the minimum requirements mentioned in Table 3.3. However, we
recommend compliance with the optimum requirements to benefit from optimum
performance.
Component
Minimum requirements
ROWE Scan 850i
Optimum
requirements
ROWE Scan 850i
CPU
3.0 GHz Dual-Core
3.0 GHz Quad-Core
Memory
4.0 GB
8.0 GB
Hard disc
5,400 rpm SATA
5 GB free memory
Solid State Drive (SSD)
50 GB free memory
Interface
High Speed USB (2.0)
Super Speed USB (3.0)
Operating
system
Windows 7 (32 bits)
Windows 10 (64 bits)
Screen
Size: 17"
Resolution: 1,280 x 1,024
Size: > 19"
Resolution: > 1,280 x
1,024
Touch screen
(optional)
Size: 17"
Resolution: 1280 x 1024
Size: > 19“
Resolution: > 1,280 x
1,024
Table 3.3: PC requirements for ROWE Scan 850i with ROWE APPS
Administrator rights are required for installation of the ROWE Scan 850i
software on your PC.
In exceptional cases, a USB 2.0/3.0 host controller chip set may not be
compatible with the high performance transfer mode of the ROWE Scan 850i.
We recommend to use hardware meeting these requirements. A current list of
compatible USB chip sets is available on request.