already on the next medium. When creating a
profile later, you can then skip this step.
In the next step, the printed target needs to be
scanned.
Allow the target to dry for about one hour, as
the colors may still change during this period.
After the drying time, place the target in the scanner
and click "Next". The target is scanned and the ICC
profile is calculated automatically. This process may
take a few minutes.
If you want to optimize the reproduction of the gray
scale of the printer additionally, you can perform a so-
called gray balance optimization. For this purpose,
another target which has been optimized for the gray
scale reproduction is printed and scanned. Simply
follow the instructions on the screen.
Normally, gray balance optimization is not
required. On request you can skip this step.
Afterwards you can complete the process by pressing
"Finish".
Figure 8.14: Inkjet profiling -
target
8.5.4 Configuring Printer
If you want to configure the settings of a printer
already installed, select the option "Configure
printer" under "Printer". Afterwards, you are
prompted to select the printer to be configured.
The list shows all printers already installed.
Afterwards press "Next".
Figure 8.15: Printer selection
To Next Page
Loading...
