By actuating "Finish“ (Fehler!
Verweisquelle konnte nicht gefunden
werden.), the driver installation is being
completed.
Figure 4.16: Driver installation finished
4.9 Establishing Connection to Scanner
After having restarted the computer, start
the Setup Wizard via Start → Programs →
ROWE Scan Series and follow the
instructions.
Figure 4.17: Start Setup Wizard
The Setup Wizard now establishes the
connection between scanner and computer
automatically. This process may take some
time depending on the PC performance.
If you actuate the "Cancel" button
during the connection process,
installation is canceled.
If the connection cannot be
established, check the connection
lines and whether the scanner is
switched ON. If the operating LED is
flashing, the scanner is in energy
saving mode. If so, actuate the
green key ("Start") on the device
once.
Figure 4.18: Connection establishment
To Next Page
Loading...
