3.6 Connection of ROWE Scan 850i to Power Supply
Before using the ROWE Scan 850i, connect the scanner to the power supply using the
power unit. Plug the connector socket of the supplied power unit into the connection on
the back of the scanner. Plug the connector of the power unit into a socket. Please
absolutely observe the following:
The scanner must only be connected to a grounded socket with VDE
homologation.
The socket has to be protected by fuses (10 A).
When several devices are connected to one socket using an extension cord
and/or a multiple socket, the total current draw shall not exceed 10 A.
The socket has to be located near the scanner.
To Next Page
Loading...
