4.3 Calibration File
Footscan 9 will try to automatically download the latest calibration file(s) for
your system. This is done automatically in the background when the software
is starting up. Should a new calibration file be available, footscan 9 will ask
you if you want to proceed to replace your current calibration file with the
updated version. Depending on your operating system, you may require
administrator rights to allow this action.
The calibration file holds the factory calibration information of your footscan device, a
new calibration file can be installed through the license and hardware calibration dialog
(Figure 8).
Figure 8: The License and hardware calibration dialog lists all connected footscan
devices.
Click Install calibration file... to install a new calibration file. More information about
the license and hardware calibration dialog can be found in 6.3
The license and hardware calibration dialog can be opened in two location:
1. By clicking the Manage calibration button in the Security Dialog (Figure 9). More
information about the security dialog can be found in section 4.1.
Figure 9: The license and hardware calibration dialog can be opened in the security
dialog.
2. By clicking the License and hardware calibration button in the Homescreen
(Figure 10). More information about the home screen can be found in section 6.
®
®
®
®
To Next Page
Loading...