48 en | Menu Structure DBP Digital Beltpack
2021-06 | 01 | F.01U.380.825
Technical Manual
Bosch Security Systems, LLC
Notice!
If you press and hold the A/C shaft encoder, the highlighted character turns red, and then
deletes after a couple of seconds. If you release the encoder while it is red, but before it
deletes, then nothing happens. If you press and release the shaft encoder quickly, then it
behaves like the CLR button and aborts the edit.
Similarly, if you press and hold the B/D shaft encoder, the highlighted character turns white,
and a new character inserts after a couple of seconds. If you release the encoder while it is
white, before inserting a new character, then nothing happens. If you press and release the
shaft encoder quickly, then it behaves like the SEL/MENU button and saves your edits.
5. Press the SEL/MENU button to confirm the change, or press the CLR/BACK button to
abort changes.
9.1.2 DHCP
Use the DHCP menu item to enable or disable DHCP on the belt pack.
To enable or disable DHCP, do the following:
1. Navigate to the DHCP menu item (Setup|Network|DHCP).
2. Press the SEL/MENU button.
3. Rotate either shaft encoder to toggle between options.
4. Press the SEL/MENU button to confirm the change, or press the CLR/BACK button to
abort changes.
9.1.3 IP Address
Use the IP Address menu item to configure the IP Address for the belt pack.
Validation on address fields occur when you try to save them. If an address is invalid, an error
prompt displays.
Notice!
Modifications to this field are allowed only when DHCP is disabled.
To configure the IP Address, do the following:
1. Navigate to the IP Address menu item (Setup | Network | IP Address).
To Next Page
Loading...
