RTS DBP 5F - Bluetooth out

78 en | Menu Structure DBP Digital Beltpack
2021-06 | 01 | F.01U.380.825
Technical Manual
Bosch Security Systems, LLC
To select the input sources routed to OMNEO Ch2 Out, do the following:
1. Navigate to the OMNEO Ch2 Out menu item (Audio | Mixers | OMNEO Ch2 Out).
2. Press the SEL/MENU button.
The field becomes active.
3. Rotate the A/C shaft encoder to scroll through the selections.
4. Rotate the B/D shaft encoder to select or deselect the item.
5. Press the SEL/MENU button to confirm the change, or press the CLR/BACK button to
abort changes.
9.12.7 Bluetooth Out
Use the Bluetooth Out menu item to select the input source routed to the Bluetooth device.
i
Notice!
This menu item does not appear if a Bluetooth dongle is not detected on the USB port.
By default, Active Mic is selected.
Available options for this field are From Intercom, 3.5mm Aux In, OMNEO Ch2 In, and Active
Mic.
To select the input source to route to Bluetooth Out, do the following:
1. Navigate to the Bluetooth Out menu item (Audio | Mixers | Bluetooth Out).
2. Press the SEL/MENU button.
The field becomes active.