DBP Digital Beltpack Menu Structure | en 49
Bosch Security Systems, LLC
Technical Manual
2021-06 | 01 | F.01U.380.825
2. Press the SEL/MENU button.
The first octet highlights.
3. Rotate the B/D shaft encoder to make changes.
OR
Rotate the A/C shaft encoder to move to the next octet.
4. Repeat step 3 until the address is complete.
5. Press the SEL/MENU button to confirm the change, or press the CLR/BACK button to
abort changes.
Notice!
Changes to this menu result in a device reboot.
9.1.4 Netmask
Use the Netmask menu item to configure or change the Netmask address. Netmask addressing
subdivides a network, and in turn alleviates heavy network traffic in large systems.
Validation on address fields occur when you try to save them. If an address is invalid, an error
prompt displays.
Notice!
Modifications to this field are allowed only when DHCP is disabled.
To configure the Netmask, do the following:
1. Navigate to the Netmask menu item (Setup | Network | Netmask).
2. Press the SEL/MENU button.
The first octet that is not 255 highlights.
To Next Page
Loading...
