Machine setup
255
12. Menu Overview and Advanced Features
- On-Forced: Set the Eco mode on with password. If a user wants
to turn the Eco mode off, the user needs to enter the password.
If you set this mode to off, the Eco mode print job from the driver will not be
calculated as a Eco mode nor will the Eco mode LED on the control be on.
• Eco Features Configuration: You can set the default options for Eco
mode.
- Factory Default: You can keep the default settings.
- Custom Settings: You can set printing from copy and PC driver
print settings related settings. The settings you set here will be
applied to all copy print and PC driver print jobs sent to the
machine, unless the user disables Eco mode.
3
Press OK to save the change or (Back) to return to the previous
screen.
Initial Settings
You can change the initial settings when you first turn the machine on.
1
Press Machine Setup > Initial Settings from the display screen.
2
Press the language to use on the display screen and then press Next.
3
Enter the password to use and then press Next. Re-enter the password
to confirm it, then press Done > Next.
4
Set the time on the machine. Then press Next.
5
Remove the existing device name and enter the device name you want
to use and then press OK. Then press Next. If necessary, enter the
location of the machine in the Location field. If necessary, enter the
information in the Administrator field for the person to contact when
any problem occurs on the machine.
6
When Connected appears after pressing the Test button, press Next.
If Not connected appears, make sure that the machine is connected to
the network then verify the LAN connection again.
If a network connection problem persists, contact your network
administrator.
7
Enter the IP address, subnet mask, and gateway in each field. Then press
Next
.
• If a new IP address is assigned automatically by a DHCP or BOOTP, press
DHCP or BOOTP.
• If you are not sure about your network environment, contact your
network administrator.
8
Enter the Host Name, Domain Name, Primary DNS Server and
Secondary DNS Server in each field. Then press Finish.
9
The completed window appears. Press the Close button.
If the engine is busy, the machine might take longer to reboot.
To Next Page
Loading...
Need help?
General