Loading originals
73
4. Media and tray
3
Close the RADF.
• Leaving the RADF open while copying may affect copy quality and toner
consumption.
• Dust on the scanner glass may cause black spots on the printout. Always
keep it clean.
• If you are copying a page from a book or magazine, lift the
RADF until its
hinges are caught by the stopper and then close the lid. If the book or
magazine is thicker than 30 mm (1 inch), start copying with the lid open.
• Be careful not to break the scanner glass. You may get hurt.
• Do not put hands on the scanner glass while closing the
RADF. The RADF
may fall on your hands and cause injury.
• Do not look at the light inside of the scanner while copying or scanning.
It is harmful to eyes.
2
In the reverse automatic document feeder (RADF)
Preparing originals
• Do not load paper smaller than 140 x 140 mm (5.5 x 5.5 inches) or larger than
297 x 432 mm (11.7 x 17 inches).
• The RADF can automatically detect A5 LEF, Letters or A4 SEF, Legal SEF, A3
SEF.
• Do not attempt to load the following types of paper, in order to prevent
paper jams, low print quality, and machine damage.
- Carbon paper or carbon-backed paper
- Coated paper
- Onion skin or thin paper
- Wrinkled or creased paper
- Curled or rolled paper
- Torn paper
• Remove all staples and paper clips before loading.
• Make sure any glue, ink, or correction fluid on the paper is completely dry
before loading.
• Do not load originals that include different sizes or weights of paper.
• Do not load booklets, pamphlets, transparencies, or documents with other
unusual characteristics.
Using the RADF, you can load up to 100 sheets of paper (80 g/m
2
, 20 lb bond) for
one job.
1
Flex or fan the edge of the paper stack to separate the pages before
loading originals.
To Next Page
Loading...
Need help?
General