Sartorius Cubis MCE - Page 28

28 Operating Instructions Cubis
®
MCE
Operating Concept
Level 1 Level 2 Level 3 Description
APPLIC.
“Applications”
TAR./STAT.
“Tare / statistics”
Activate | deactivate automatic taring for the
“Statistics” application.
UPDATE Start a firmware update. The menu is only available
if a USB mass storage device is connected.
INPUT ID NO. Save the entered ID number for the device.
LOT ID − Activates | deactivates the printout of a line for
the LOT ID in the GLP printout.
− The LOT-ID can be entered in writing in the line.
DATE Set the date.
TIME Set the time.
USER.PASS. Set the user password.
DEL.PASS. Delete the user password. The menu is only
available if a user password is set.
SERV.PASS. Activate the service mode.
CAL.WT.
“Calibration
weight”
Define the value of the external user calibration
weight.
INTERV. Change the interval for automatic data output for
parameters “DATA.OUTP./COM.SBI /AUTO.CYCL./
INTERV.” and “DATA.OUTP./PRNT.PARA./
ACTIVATE/INTERV.”.
INFO
“Device
information”
VERSION
“Version number”
Display the software version number.
SER. NO.
“Serial number”
Display the device’s serial number.
MODEL Display the device’s model ID.
APC VER. Display the software version of the APC processor.
BAC VER. Display the software version of the BAC processor.
MCU VER. Display the software version of the MCU processor.
WPC VER.
“Draft shield
version”
Display the draft shield software version.
LANGUAGE Change the menu language.
Overview of the “Toggle between weight units” Function
t Navigating in Menus (see Chapter 4.6, page 29).
Level 1 Description
Unit 1 Define the displayed weight unit and the resolution for the 1st convertible unit.
Unit 2 Define the displayed weight unit and the resolution for the 2nd convertible unit.
Unit 3 Define the displayed weight unit and the resolution for the 3rd convertible unit.
Unit 4 Define the displayed weight unit and the resolution for the 4th convertible unit.