Operating Instructions Cubis
®
MCE 45
System Settings
Parameters Setting values Explanation
ST.DEL. NONE Sets the stability delay to “none”: The stability symbol is displayed after the
stability criterion is reached.
SHORT* Sets the stability delay to “short”: The stability symbol only appears after a short
delay in order to provide a reliable result despite fluctuations.
MEDIUM Sets the stability delay to “medium”: The stability symbol only appears after a
longer delay in order to provide a reliable result in case of higher fluctuations.
LONG Sets the stability delay to “long”: The stability symbol only appears after a long
delay in order to balance out major instability.
ZERO/TAR. W/O STB. Without stability: The function of the [Zero] or [Tare] key is executed
immediately once the key is pressed.
W/ STAB.* With stability: The function of the [Zero] or [Tare] key is only executed after
stability is achieved.
AT STAB. At stability: The function of the [Zero] or [Tare] key is executed if stability exists
when the key is pressed.
AUTOZER. ON* − Activates automatic zeroing.
− The display is automatically set to zero in case of a deviation of 0 less than (X).
OFF Deactivates automatic zeroing. Zeroing must be triggered with the [Zero] key.
UNIT The availability of units may depend on national legislation and is therefore
country-specific.
GRAMS* The device displays the weight in grams.
KILOGR. The device displays the weight in kilograms (not for semi-microbalances and
microbalances).
CARATS The device displays the weight in carats.
POUNDS The device displays the weight in pounds (not for semi-microbalances and
microbalances).
OUNCES The device displays the weight in ounces (not for microbalances).
TROY OZ. The device displays the weight in troy ounces (not for microbalances).
HKTAEL The device displays the weight in taels – Hong Kong (not for microbalances).
SNGTAEL The device displays the weight in taels – Singapore (not for microbalances).
TWNTAEL The device displays the weight in taels – Taiwan (not for microbalances).
GRAINS The device displays the weight in grains.
PENYWT. The device displays the weight in pennyweights.
MILLIGR. The device displays the weight in milligrams (not for high-capacity precision
balances).
CHINATAEL The device displays the weight in taels – China (not for microbalances).
MOMMES The device displays the weight in mommes.
TOLA The device displays the weight in tolas.
BAHT The device displays the weight in baht (not for microbalances).
MESGHAL The device displays the weight in mesghals.
NEWTON The device displays the weight in newtons (not for microbalances).
* Factory setting
To Next Page
Loading...
