Cubis MSU User Manual 149
Updating the Software
3) Upload the Software Update to the Balance
t If you are working with User Management (user profiles are defined),
the software can only be updated by the administrator.
t Toggle to the System Settings menu.
t Open the Update software submenu.
y You are asked if you want to delete the existing profiles.
t Select No or Yes.
t Once the SD card with the current software is inserted, select Next.
If the following error message appears:
Wrong XML version. Please check the data.
t Touch Next.
y All previous data will be saved in the new format.
t After updating your software, check your settings (Menu, TASK and USER).
t If the XML files continue to cause problems, contact your local Sartorius
Service Center.
y After a version check is run, the versions of the current and the new software
are displayed.
t To start the update, select Continue.
y An acoustic signal will sound when the update is complete, and the balance
then carries out a self test.
Audit Trail for Software Download on Models Verified for Legal
Metrology
Software Status of the Balance
Models verified for use in legal metrology are assigned an authorized software sta-
tus when the balance is shipped for delivery. This can be indicated on the display.
If something concerning the software or the legal regulations changes, the software
status must be updated.
Displaying the Audit Trail of the Balance Software
t Turn off the balance and disconnect it from the power supply.
t Hold down A and reconnect the balance to the power supply.
y The “Bios” menu is displayed.
t Press the “Show settings” menu item.
t Select the “Audit trail of software updates” menu item.
t Select “Show audit trail.”
y The Audit Trail with modification date, name, new and old software, and ver-
sion number are indicated on the display.
To Next Page
Loading...
