Task Management (TASK)
54 Cubis MSU User Manual
Using Applications with the Factory Settings
Each application comes with specific factory settings.
If you want to apply these settings unchanged, you can do this quickly during
configuration:
D t Open Task Management and select Edit.
t Select Create.
y An application list is displayed.
t Select the application you want to assign to the new task.
t Select Done.
t Enter a name and a description for the task and select Save.
y The new task is saved with the factory settings and displayed in the task list.
Sorting the Task List
New tasks are always added to the end of the task list. After you have configured
several tasks, it may be helpful to sort the task list.
D y The task selection is displayed.
t Select Sort.
y The list is sorted alphabetically (A – Z).
t To reverse the sort order, select Sort again.
t To sort tasks by the date of last use, select Sort again.
Creating New Tasks (Configuration)
The Cubis software contains the following applications that you can configure
as tasks as required:
– Weighing – Weighing in percent
– Mass unit conversion – Timer-controlled functions
– SQmin minimum weighing (optional) – Totalizing
– Individual identifiers – DKD uncertainty of measurement (optional)
– Density determination – Second tare memory (preset tare)
– Statistics – Parts counting
– Calculation – Checkweighing
– Averaging – Draft shield (optional)
– Formulation – Ionizer (optional)
To Next Page
Loading...
Need help?
General
