Cubis MSU User Manual 177
Declarations of Conformity
Declarations of Conformity
Weighing instruments for use in legal metrology: Council Directive 90/384/EEC
“Non-automatic Weighing Instruments”
This Directive regulates the determination of mass in legal metrology.
For the respective Declaration of Conformity for weighing instruments that have
been verified by SARTORIUS for use as legal measuring instruments and that have
an EC Type-Approval Certificate, see next page.
This Directive also regulates EC verification by the manufacturer, provided that an
EC Type Approval Certificate has been issued and the manufacturer has been
accredited by a Body registered at the Commission of the European Community for
performing such verification.
The legal basis for Sartorius to perform the EC verification is EC Directive No.
2009/23/EC for non-automatic weighing instruments. This Council Directive
has that has been in effect since January 1, 1993 within the EU. The further legal
basis is founded on the Sartorius AG Quality Management System issued by
the Metrology Department of the Regional -Administration Office of Lower Saxony,
Germany (“Niedersächsisches Landesverwaltungsamt - Eichwesen”)
on February 15, 1993.
“Installation” Service in Germany
Our “Installation” service package provides a range of important services that
guarantee satisfactory work from your balance:
– Setup
– Getting Started
– Inspection
– Training
If the installation of the weighing instrument is to be carried out by Sartorius,
please request this service from a customer service employee.
Re-verification in Germany
Balance verification for legal metrology is valid until the end of the calendar year
after next.
If the balance is used for fill level control in accordance with legislation on
prepackaging, verification is valid until the end of the following calendar year.
Re-verification must currently be carried out by a weights and measures official.
Re-verification should be requested in good time from the local Weights and
Measures office. As appropriate, please observe all statutory amendments.
Re-verification within Europe and Outside of Germany
The expiration date of the verification depends on the national regulations
of the country in which the weighing instrument is used. For information on verifi-
cation and legal regulations currently applicable in your country, and to obtain
the names of the persons to contact, please contact your local Sartorius office,
dealer, or Service Center.
Further information concerning verification can be obtained from our customer
service
To Next Page
Loading...
Need help?
General
