Using the Balance
Cubis MSU User Manual 31
Display and Control Unit
The tilt angle of the display and control unit can be set as desired to enable optimal
readability for changing working conditions. The color and brightness of the display
can also be changed to match the illumination in the room.
(see “User Management” and “System Settings”).
SD Memory Card for Data Exchange
The display and control unit is equipped with a slot for an SD memory card where
you can import and export data (tasks, user profiles). Handling the memory card
is explained in Section Importing/Exporting Data.
Setting the Language
y The default language for the display is English.
t To change the language, select Menu and then Lang.
t Use the cursor softkeys to select the desired language.
y The display changes directly to the selected language.
t If you would like to select a language that was not included with the equip-
ment supplied but was later downloaded from the Cubis website, you must first
import the language file (see Section “Importing/Exporting Data”).
y To display the downloaded language, select the last option in the language list
(“Reloadable language”) and then select the desired language.
Quick Guide: First Weighing
A t Press the on/off key Ato turn on the balance.
t Close the draft shield (if your model has one).
J t Press the tare key J to tare the balance.
y The balance is tared, and the displayed value is zero.
t If required, open the draft shield and carefully place the sample on the weigh-
ing pan (in a suitable container if required).
t Close the draft shield (if your model has one).
t You can read the measured value as soon as the weight value stops changing
and the unit is displayed.
To Next Page
Loading...
Need help?
General
