4 Cubis MSU User Manual
Safety Instructions
This device complies with European Council Directives as well as international
regulations and standards for electrical equipment, electromagnetic compatibility,
and the stipulated safety requirements. Improper use or handling can, however,
result in damage and/or injury.
This device should only be operated by trained personnel.
Operators must read these installation instructions, particularly the safety informa-
tion, and must be familiar with the operation of the equipment. The operator
is required to supplement these safety precautions as appropriate. The operating
personnel must be provided with the appropriate training. The requirements per-
taining to applicable installation regulations must be followed when using electrical
equipment in systems and environmental conditions with increased safety require-
ments. Relevant laws, standards, regulations, guidelines, and environmental
protection laws valid in your country must be observed.
Always keep the equipment and balance freely accessible.
Any installation work or balance usage that does not conform to the instructions
in this manual results in forfeiture of all claims under the manufacturer’s warranty.
Danger of explosion!
1
Do not use this equipment in hazardous areas in which explosive materials
are present.
Danger of electrical shock!
2
Make sure that the voltage rating printed on the AC adaptor is identical to your
local line voltage. The wall outlet must have a protective grounding conductor.
The operating instructions included with the AC adaptor must be followed.
2
Do not switch on the equipment if the AC adaptor or power cord are damaged.
If the balance, the AC adaptor or any of the cables are damaged, disconnect
the equipment from the power supply and secure it so that it cannot be turned on.
2
Chemicals (e.g., gases or liquids) that can corrode and damage the inside or outside
of the balance, AC adaptor, power cable, or peripherals must be kept away from
the equipment.
2
Do not operate the balance unless the housing and the display are undamaged
and the housing is closed so that inadvertent contact with parts inside the
equipment is not possible. Make sure that no liquids penetrate the balance.
2
Installation note:
The operator shall be solely responsible for any modifications to the equipment
and for connecting any cables or equipment not supplied by Sartorius.
Information on operational quality is available upon request from Sartorius.
You should only use peripherals and options available from Sartorius.
Note on cable quality:
CE conformity is only guaranteed with well shielded cables.
The shielding braid of the cable must be made of metal with at least 80% coverage
and also covered with metal foil as much as possible. The shielding on both sides
on the full metal or metal connector casing, as well as on the casing inlet, must
be high-frequency compliant and have a flat design.
Safety Instructions
To Next Page
Loading...
Need help?
General
