Task Management (TASK)
62 Cubis MSU User Manual
Combining Applications into One Task
You can combine applications that are saved in the balance into one
task. The following rules need to be followed (see table below):
– An application can only be combined with applications from different groups.
– You can only combine the applications of the first three groups in the
order given below, e.g., weighing, checkweighing, and totalizing, but not weigh-
ing, totalizing, and checkweighing in that order.
– The applications of the Additional Functions group can be combined freely; the
order is not relevant in this case.
When you combine applications, the Cubis software automatically suggests only
those applications that follow these rules.
Application
Weighing
Density determination
*
*
Calculation
*
*
Averaging
Weighing in Percent
*
*
Parts Counting
*
*
Timer-controlled actions
Checkweighing
Statistics
Formulation
Totalizing
Mass unit conversion
SQmin function
*
**
*
*
Individual Identifiers
DKD measurement uncertainty
*
**
*
*
Second tare memory
Draft Shield
Ionizer
Weighing
Mass unit conversion
SQmin function
Individual Identifiers
Density Determination
Statistics
Calculation
Averaging
Formulation
Weighing in Percent
Timer-controlled actions
Totalizing
DKD Measurement Uncertainty
Second Tare Memory
Parts Counting
Checkweighing
Draft Shield
Ionizer
Application group
Calculating
applications
Che-
cking
applica-
tions
Log ging
applic ations
Additional functions
Weighing is always available
Combination possible
Combination possible is only activated as long as no calculating applications
is active.
No combination with identical application possible
No combination with an application of the same group possible
No combination possible because it is not meaningful
*
To Next Page
Loading...
Need help?
General
