Cubis MSU User Manual 29
Getting Started
Using the Balance
Turning the Balance On/Off
t Make sure the balance has been installed and put into operation in accordance
with the installation instructions.
A t Press the on/off key A on the control unit.
y The start screen appears briefly on the display, and then the user interface
appears.
h
On subsequent starts, the most recently active user profile and task are opened
(if at least one user profile has been set up).
t If prompted, level the balance (see Section “Level the Balance” for details).
A t To switch the balance to standby mode or turn it off, press the A key.
t Close the draft shield (if your model has one).
Operating Design: Q-Guide
Cubis precision and analytical balances are controlled by application software with
interactive operator guidance. Once you open a menu or select an application, brief
instructions appear on the display to guide you through the menu or application
step-by-step. At each step along the way, the display shows only those options that
are relevant to your process; this helps prevent unnecessary “detours” and enables
you to reach your goal more quickly.
This type of user guidance is mostly intuitive. Although operation of the balance
is also mostly intuitive, this manual includes a section with very detailed, step-by-
step instructions where you can learn about all of the available options
(see “Creating User Profiles” in Section “User Management”).
Basic Operational Structure
The most basic functions, weighing and taring, can be carried out as soon
as the balance is switched on. The application software is divided into three general
areas in which individual settings can be configured:
In Task Management (TASK), task profiles with specific applications, weighing
settings, and printout settings can be configured.
User Management (USER) lets you set up user profiles with specific configuration
settings and user rights. You can also set up password protection to meet your
security requirements. Your balance can also be used without User Management.
Simple Weighing
D TASK
Task Management (from page 53)
Selecting and starting applications
Configured
at factory
Configured
by user
System Settings (from page 35)
Configuring applications
Configuring tasks
Creating user profiles
H USER
User Management (from page 119)
Selecting user profiles
To Next Page
Loading...
