Satel Versa - Page 86

84 VERSA SATEL
1. Run the update program for control panel firmware.
2. Click on the button.
3. In the window that will be displayed, indicate the COM port of the computer to which the
control panel is connected, check the RESTART option and click “OK”.
4. Power off the control panel (disconnect AC mains first, and the battery next).
5. Power up the control panel (first connect the battery and then the AC power).
6. The firmware updating program will establish communication with the control panel.
7. When a prompt window is displayed asking you whether to continue the firmware update,
click “Yes”. The control panel firmware will be updated.
The control panel will only wait 10 seconds after power-up for the firmware update to
begin.
15. Manual update history
The table presents changes made since version 06/15.
Manual version Introduced changes
10/15
17).  Information on the required DLOADX program version has been updated (p.

Description of the S
ERVICE MESSAGE AFTER TAMPER ALARM option has been
modified (p. 28).

Description of the S
IGNALING ON INTERNAL SIRENS option has been added (p. 39).
 Table indicating how the zone options are presented in keypads has been
updated (p. 40).

Description of the 22. ETHM
TROUBLE STATUS output function has been added
(p. 42).

List of troubles, the occurrence of which can trigger the 22. ETHM
TROUBLE
STATUS
function output has been added (p. 43).
 Description of the P
ULSE output option has been modified (p. 45).
 Table indicating how the output options are presented in keypads has been
updated (p. 46).

Information on the VERSA-LCDR keypad has been added in the volume
configuration section (p. 49).
04/16
17).  Information on required DLOADX program version has been updated (p.

Description of E
NTRY DELAY IN DAY ARM option has been added (p. 33).
 Section “Proximity cards” has been added (p. 50).

Description of U
SER CAN REPLACE VERSA-LCDM-WRL BATTERY option has been
added (p. 54).

Information on ASP-100 siren has been added (pp. 54, 55, 56, 58 & 61).
56, 57 & 59). 
Information on AOD-200 detector has been added (pp.
 Section
“ABAX wireless sirens” has been modified (p. 62).
11/17
17).  Information on required DLOADX program version has been updated (p.

Description of B
ACKLIGHT OFF ON AC LOSS option has been added (p. 29).
 Description of E
NTRY DELAY IN NIGHT ARM option has been added (p. 33).
 Section “Hardware
” has been added (p. 40).
 Name of the S
ATEL SERVER (LAN) option has been changed to LAN (p. 51).
 Description of D
O NOT REPORT SATEL SERVER CONNECTION TROUBLE option has
been added (p. 51).

Description of A
LARM 3 INCORRECT CODES (MOBILE APPLICATION) option has been
added (p. 52).

Description of P
USH NOTIFICATIONS option has been added (p. 52).