EasyManuals Logo

SeaDoo GTX 4-TEC Supercharged User Manual

SeaDoo GTX 4-TEC Supercharged
801 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
SAFETY NOTICE
SAFETY NOTICE
This manual has been prepared as a guide to correctly service and repair all 2004 SEA-DOO watercraft.
See model list below.
This edition was primarily published to be used by watercraft mechanical technicians who are already fa-
miliar with all service procedures relating to Bombardier made watercraft. Mechanical technicians should
attend training courses given by Bombardier Training Dept.
Please note that the instructions will apply only if proper hand tools and special service tools are used.
This Shop Manual uses technical terms which may be slightly different from the ones used in the Parts
Catalog.
It is understood that this manual may be translated into another language. In the event of any discrepan-
cy, the English version shall prevail.
The content depicts parts and/or procedures applicable to the particular product at time of writing. Ser-
vice and Warranty Bulletins may be published to update the content of this manual. Make sure to read
and understand these.
In addition, the sole purpose of the illustrations throughout the manual, is to assist identification of the
general configuration of the parts. They are not to be interpreted as technical drawings or exact replicas
of the parts.
The use of Bombardier parts is most strongly recommended when considering replacement of any com-
ponent. Dealer and/or distributor assistance should be sought in case of doubt.
The engines and the corresponding components identified in this document should not be utilized on
product(s) other than those mentioned in this document.
WARNING
Torque wrench tightening specifications must be strictly adhered to. Locking devices (ex.: lock-
ing tab, self-locking fasteners, etc.) must be installed or replaced with new ones. If the efficiency
of a locking device is impaired, it must be renewed.
WARNING
Unless otherwise specified, engine should be turned OFF and cold for all maintenance and repair
procedures.
This manual emphasizes particular information denoted by the wording and symbols:
WARNING
Identifies an instruction which, if not followed, could cause serious personal injury including pos-
sibility of death.
CAUTION: Denotes an instruction which, if not followed, could severely damage vehicle compo-
nents.
NOTE: Indicates supplementary information needed to fully complete an instruction.
Although the mere reading of such information does not eliminate the hazard, your understanding of the
information will promote its correct use. Always use common shop safety practice.
Bombardier Inc. disclaims liability for all damages and/or injuries resulting from the improper use of the
contents. We strongly recommend that any services be carried out and/or verified by a highly skilled
professional mechanic. It is understood that certain modifications may render use of the vehicle illegal
under existing federal, provincial and state regulations.
XII
www.SeaDooManuals.net

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SeaDoo GTX 4-TEC Supercharged and is the answer not in the manual?

SeaDoo GTX 4-TEC Supercharged Specifications

General IconGeneral
Seating Capacity3
ModelGTX 4-TEC Supercharged
Displacement1494 cc
ManufacturerSea-Doo
CategoryPersonal Watercraft
Fuel TypeUnleaded gasoline

Related product manuals