Section 04 ENGINE (2-STROKE)
Subsection 02 (REMOVAL AND INSTALLATION)
REMOVAL AND INSTALLATION
GENERAL
On some models, it is not necessary to remove
engine from watercraft to service TOP END, PTO
FLYWHEEL or MAGNETO. However, engine re-
moval is necessary to repair BOTTOM END.
ENGINE REMOVAL
DI Models
Use the VCK (Vehicle Communication Kit) (P/N 529
035 981) and release the fuel pressure in the fuel
system. Refer to ENGINE MANAGEMENT sec-
tion.
All Models
In order to remove engine from watercraft pro-
ceed as follows.
First, disconnect battery cables from battery.
WARNING
Always disconnect battery cables exactly in
the specified order, BLACK negative cable
first then the RED positive battery cable last.
Electrical Connections
It is recommended to disconnect electrical con-
nections prior to disconnecting fuel lines.
Disconnect temperature sensor wire and spark
plug cables.
Disconnect magneto wiring harness.
F01D8RA
1
717 ENGINES
1. Unplug connector
F06D0FA
1
787 RFI ENGINES
1. Unplug connector
smr2004-Complete Line Up 71
To Next Page
Loading...
Need help?
General
