Section13PROPULSION
Subsection 01 (JET PUMP)
F18J1YA
3
15
62
4
TYPICAL
From 1 to 2: 16 N•m(12lbf•ft)
From 3 to 6: 31 N•m(23lbf•ft)
NOTE: Slightly lubricate wear ring with BOM-
BARDIER LUBE lubricant to minimize friction
during initial start.
Nozzle
Insert bushing no. 27 in nozzle no. 42.
Insert bushing no. 26 in nozzle no. 42 with its off-
set pointing rearward.
1
F18J0GA
1. Bushing offset
Position their flanges from inside of nozzle.
Insert sleeves no. 28 in bushings no. 27 and
no. 26.
Install nozzle on venturi no. 23; position its steer-
ing arm on RH side. Apply Loctite 243 (blue) on
screw threads (or use new self-locking screws).
Install screws no. 30 and washer no. 29 then
torque to 24 N•m(18lbf•ft).
WARNING
Screws must be torqued as specified.
O.P.A.S.
Reconnect O.P.A.S. hose (if applicable). Torque
clamp screw to 1.7 N•m(15lbf•in).
Fasten O.P.A.S. “U” levertonozzleandside
levers. Apply Loctite 243 (blue) on screw threads
(or use new self-locking screws). Torque center
screwto20N•m(15lbf•ft) and side screw to
7N•m(62lbf•in).
Pivot Triangle
Install head bolts toward inside.
NOTE: Make sure the pivot triangle turn freely.
Reverse Gate
Install reverse gate with spacer and washer.
Torque to 20 N•m(15lbf•ft).
NOTE: When installing the reverse gate, pay at-
tention to position its lever behind the reverse
gate support stopper.
F07J07A
1
1. Stopper
smr2004-Complete Line Up 651
To Next Page
Loading...
Need help?
General
