HF Series Generators
Data Book
DB-1004R4
1
SECTION 1 INTRODUCTION
This Data Book is the register of the Configuration and Calibration data of the
Generator and the register of each Periodic Maintenance Service carried out.
Keep this book always with the equipment for reference.
Enter the data with a pencil in order to modify them later due to
future changes.
If the HT Controller Board or the ATP Console CPU Board are
replaced, check specially that Extended Memory data have
not been lost or modified with the Board change. Compare
Extended Memory data displayed on the Console with the
values noted in this document.
Also, make some exposures using different techniques and
Focal Spot and check that mA stations are calibrated
correctly, if not perform Calibration procedures.
Verify that “Configuration Control Sheet” and “Final Test Results”
pages from factory have been included with the equipment.
1.1 INSTALLATION DATA
Enter the following information.
HOSPITAL
INSTALLED AND TESTED BY DATE
Note .
Note .
To Next Page
Loading...