HF Series Generators
Installation
IN-1052R0
22
3.3.2 TUBE SELECTION SIGNALS
This section only applies to Generators with two X-ray Tubes.
The Tube Selection signals are available through two contacts free of voltage
locatedonthestarter.
TUBE-1 SELECTION TUBE-2 SELECTION SELECTION COMMON
on the LF-RAC Board J1-10 J1-11 J1-12
on the LV-DRAC Module 11KT1-84 11KT1-72
11KT1-83 and 11KT1-71
(connect both)
3.4 INTERCONNECTION CABLES
This section identifies the cables and runs needed for Generator and System
Interconnection. Route and connect the interconnection cables from each
component installed in the system to the Generator Cabinet as indicated in
Illustration 3-2 and Section 5.2 -- Interconnection Maps “543010XX”.
Interconnection cables should not be routed into the same
conduit or cable raceway as the Power or High Voltage
cables.
Note .
To Next Page
Loading...