Sedecal SHF-310 - Section Page

HF Series Generators
Configuration
CF-1018R3
i
TABLE OF CONTENTS
Section Page
1 INITIAL CONFIGURATION PROCEDURE 1...................................
1.1 Configuration and Test Switches 3......................................
1.1.1 3024SW1 - ATP Console CPU Board 3...........................
1.1.2 3024SW2 - ATP Console CPU Board 3...........................
1.1.3 3024SW3 - ATP Console CPU Board 4...........................
1.1.4 3024SW4 - ATP Console CPU Board 4...........................
1.1.5 3000SW2 - HT C ontroller Board 4...............................
1.2 Basic Configuration of Generator Boards 5...............................
1.3 AEC Configuration 6..................................................
1.4 FLUORO Configuration 7..............................................
1.5 Generator Service Mode 9.............................................
1.6 Exposure Counters 11.................................................
1.7 Workstations Configuration 12...........................................
2 EXTENDED MEMORY SETTING 17...........................................
2.1 Extended Memory Locations 17.........................................
2.2 How to Enter and Store Data in the Extended Memory 19...................
2.3 Limit of Maximum kW 21...............................................
3 X-RAY TUBE SELECTION 23................................................
3.1 X-ray Tube Insert Protection Curves 23...................................
3.2 Generators with LF-RAC (Low Speed Starter) 24..........................
3.2.1 Stator Voltage and Capacitor Selection 24.........................
3.2.1.1 Configuration for One or Two Tubes with Standard Stator 24
3.2.1.2 Configuration for One or Two Tubes with the same
Starting Voltage at 110 VAC 24..........................
3.2.1.3 Configuration for Two Tubes with Different
Starting Voltage and Capacitor or One Tube
with Starting Voltage at 330 VAC 25......................
3.2.2 Programming of Rotor Acceleration Time, RAD Filament Setting Time,
FLUORO Rotor and Filament Hold-over Time 27....................