Segway®PTi2,x2,x2TurfPartsReplacementGuide D‐1
D. Recommended Tools and Diagnostic Equipment
TableD‐2listsandbrieflydescribesrequiredtoolsandequipmentthatyoushouldhaveonhandpriorto
servicingtheGen2SegwayPT
.
FASTENERS
• Use only Segway-approved fasteners.
• Do not tighten or reuse any fastener except the screws used to attach the battery packs, wheel nuts, and
LeanSteer frame. Instead, when any other fastener is loose or removed, replace the fastener with a new
Segway-approved fastener. See Appendix C, ”Fasteners” for more information.
• Before using a fastener, make certain the fastener is the correct size and type with any necessary washer
and thread lock in place (see Table C-1 on page C-1).
• Since the pre-applied thread lock compound is intended for single use only, reuse of fasteners is not
permitted with the exception of the wheel nuts, battery fasteners, and LeanSteer clamp bolt.
• Do not attempt to repair any stripped or damaged screw hole. Instead, replace the part. If replacement
part is not available, do not reassemble.
• Insert fasteners slowly and carefully. Do not cross-thread or over-tighten fasteners. Tighten only to the
prescribed torque.
• Failure to adhere to these warnings could lead to serious injury or death or damage to property.
TableD‐2:EquipmentList
TOOL DESCRIPTION
Lowpressureinflationgauge
Alcoholwipes
Cottonswabs
Caulkinggun
ESDequipment Fieldelectrostaticdischarge(ESD)kitincludesstaticmat,wriststrap,linewith
gatorclip,andgroundlead.Correctgroundingofmatandwriststrapis
essential.
Smallflatheadscrewdriver
Hexbits 2.5mm,3mm,4mm,5mm,8mm
Hexwrenches 2.5mm,3mm,4mm,5mm,8mm
1/4”squareto1/4”hexadapte
r
Loctite127864XBRTVsealant
Onetube;
ensureswater‐tightsealbetweenconsolehousingandcover
Loctite20‐gaugetapertip NeededtoapplyRTVsealant