Segway Personal Transporter i2 - Wireless InfoKey Controller Dock Removal and Installation

1‐8 Segway®PersonalTransporteri2,x2,x2TurfPartsReplacement
Wireless InfoKey Controller Dock Removal and Installation
To remove Wireless InfoKey controller dock:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Using3mmhe
xwrench,removefastener
thatholdsWirelessInfoKeycontrollerdock
toLeanSteerframe.SeeFigure1‐11.
3. Remov
eWirelessInfoKeycontrollerdock.
Figure1‐11:ReplaceWirelessInfoKeyControllerDock
To install Wireless InfoKey controller dock:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Pla
ceWirelessInfoKeycontrollerdock
againstupperLeanSteerframewithrelease
taborientedatbottom.SeeFigure1‐11.
3. Thread3m
mfastener(20306‐00003)through
holeintopofWirelessInfoKeycontroller
dockandintoupperLeanSteerframe.
4. Using3m
mhexwrench,tightenfastenerto
2.0N‐m(18in‐lbf).
5. Pe
rformpost‐servicetests(pageA‐1).
InfoKeyDock
20946-00001
20306-00003